Using the method I made last time、I modded SBDC053 because I wanted to try the 28.5mm First Diver reprint model dial that I found in Aliek as soon as possible.。 If you measure the thickness of the case + glass in the genuine state、1Because it was 0.4mm thinner than st 1、After all, it seems that the shaving of the chapter ring was sweet last time。 Because the glass gasket was 1.4 mm、1.0Only mm fits。I may fix it if I have the chance...。So, this time, I cut the chapter ring more firmly than last time, and made the thickness of the chapter ring 2.0mm.。(Actually, it is just 0.2mm thicker than the regular thickness, but due to the balance of the roulette engraving,、This was the limit...) While I was making it, I wanted to finish it quickly, so the crown was in the parts box for the time being.。The gasket for the chapter ring is also available in a similar size from Aliek this time.、I wrapped it twice again, but it was just a little loose.、For the chapter ring, I used a little double-sided tape to fix the center of the engraving.。Jubilee Breath is Aliek、Because the burr in the part that contacts the case was terrible、While polishing with a file and polishing with stainless steel polishing to create a finish that is gentle on the case、Replaced with SBDC051 buckle for a more genuine feeling。The luminescence is also nice, and the dial also has a nice color depending on the amount of light.。I like the sunray reflection、I thought it was a dial of great quality.。Ariek is terrible...。yoohiyy's、7Recommended for S26-0040! there was brown。 If you look side by side, the index placement has been slightly adjusted to match the 28.5mm diameter.、I don't know if it was originally this balance or not because I haven't seen the actual SBEX009、there was a slight difference。The part this time is a needle、Dial、The breath is Aliek and the crown is unknown, but it is a common design。Chapter ring was previously on ebay for boys。
