I'm trying to replace the windshield in my spare time.、I can't remove the bezel no matter what。ALTAS series、Although it is SKZ209、There was no gap to pry the bezel...I was thinking of forcibly removing the entire windshield from the caliber side.、I feel like the glass will just break (my bad premonitions are usually correct), but do you know how to remove it?、Please teach me。Please。
Thank you skysho for posting❗️😃
so、Atlas has to be able to remove the bezel.、with the right tools、If you use a punching piece of an appropriate size that is not too small,、Even if you just remove it as you think、I think you can get through it without breaking the glass.。
200mFor waterproofing、I think it's okay because it's thick glass.。
I can't guarantee it, but...😅
It is true that the windshield I purchased as a replacement was quite thick.、If you can prepare a frame that fits perfectly, this is one option.。Until now、There are many cases where the size of the frame does not match and the glass is damaged.、I'm scared。I'll try it carefully and slowly。Thank you very much。
skysho-san、Nice to meet you。I am a person who previously disassembled a junk Atlas.。
I'm sorry that my memory is a little fuzzy.、When I removed the bezel insert, I think there was a hole or groove that could fit into it if I used a three-point opener properly.。If I turn it counterclockwise, it seems like the bezel can be disassembled...。So first remove the glass and then remove the bezel insert.、A new world is expanding there 😄 However, I don't use the appropriate tops that Mr. Tencho said, and my inner compass spins round and round. I broke the piece by touching it with a part, so please be careful when using plastic pieces whose diameter changes at the top and bottom.(__)The gap where you have to pry the m bezel is made like a screw.、I don't think Kojiake was included.。
Thank you。I was planning to replace the bezel insert as well.、I'll try peeling it off right away.。
I tried peeling off the bezel insert.、The final boss has appeared。I don't have an opener claw that fits the ring that holds the bezel, so I'll have to make one myself...but the windshield doesn't seem to be interfering with the bezel.、It seems okay to remove it using an appropriately sized piece.。Mr.tencho、Thank you professor ichi。
Over four months have passed since then、200I was struggling to replace the waterproof windshield。The double dome breaks due to the enclosure pressure.、2.5The mm flat windshield has also been broken。After all、3.0A ×31.0mm flat windshield was enclosed with a C-clamp for woodworking.。(have)The gaskets arranged at Nakamura Watch Materials Store were 1.25cm tall x 0.4mm wide, 31.0mm inner diameter, 31.8mm outer diameter, was OK.。ladies and gentlemen、Thank you for the professor!